Astron Clearsplint Blank 98 x 20 mm,

Tizian Blanks NEM (non-precious metal) are made of beryllium-free and cadmium-free CoCr ceramic alloy according to DIN EN OSP 22674 and EN ISO 9693 for applications with thin cross-sections which are exposed to extreme forces. Examples are removable partial dentures, clasps, thin veneered individual crowns, fixed full arch dentures or bridges with small cross-sections, bars, fixations, implant-supported supraconstructions. Properties: Alloy type: 4Density: 8.8 g/cm³Vickers hardness: 285 HV 10/30CTE- value (25-500 °C): 14,4*10-6 K-1Oxidation without vacuum (Point 4c): 1000 °CMass content of the components (in weight-%)*: Co 63, Cr 29, Mo 6 / Mn x, Nb x, Si x, Fe xTensile strength: 680 MPa0.2 % yield point: 400 MPaElongation at break: 9 %E-module: 250 GPa *X= <, 1%

T32 double-edged radius cutter, long, edge Ø 0.6 mm, shaft Ø 6 mm, max. blank height = 25 mm. Processing type: fine finishing Blank material: zirconium dioxide, PMMA, wax Coating type: uncoated Ring color: gold For milling machines: Tizian Cut 5, Tizian Cut 5.2, Tizian Cut 5.2 plus, Tizian Cut 5.2 Pro, Tizian Cut 5.2 Pro plus, CORiTEC 550i, CORiTEC 750i

Tizian Blank PMMA Splint is made of a highly pure themoplastic PMMA which is produced following the highest quality standards. The crystal clear, color-stable material stands out with its homogeneity, low plaque adhesion and low water absorption. Tizian Blank PMMA Splint is an economic alternative for the splint technology. It can be be repaired and extended with PMMA acrylics. Indications: Occlusion splints Drilling templates for navigated implantation Lost wax technique in casting technology Processing: Due to the chemical and physical properties of thermoplastic PMMA, there is a risk of melting the material during dry machining and thus smearing the mills. Therefore, it is important to use only single-edged mills. If necessary, the milling strategy must be adjusted with a slower cutting speed and a lower feed rate. The material can be processed by wet machining with PMMA mills in a standard strategy without restrictions. 

Diamond radius cutter, double-edged, edge Ø 1 mm, shaft Ø 6 mm, total length 53 mm, max. blank height: 25 mm Processing type: fine finishing Blank material: zirconium, nano-composite Type: coated Coding color: gold For the milling machines: Tizian Cut 5.2, Tizian Cut 5.2 plus, Tizian Cut 5 option metal milling (6 mm shaft), CORiTEC 550i, CORiTEC 750i

Four-tooth radius cutter, double-edged, edge Ø 2 mm, shaft Ø 3 mm, total length 35 mm. For blank heights of up to 16 mm Höhe. Processing type: pilot milling Blank material: non-precious alloys Coating type: tempered Ring color: gold For milling systems: Tizian Cut 5 smart, Tizian Cut 5 smart plus